800VA 12V 35A MultiPlus Charger-Converter - Victron Energy

Description

Uninterrupted AC power (UPS function)
In case of mains failure, or of a failure of the shore or generator feed, the inverter of the Multi will automatically switch on and take over the supply to the connected loads. This transfer happens so fast (less than 20 milliseconds) that computers or other electronic equipment will not be disturbed.

Proven reliability 
The full-bridge topology with a toroidal transformer has proven its reliability over many years. The inverter is short-circuit proof and protected against overheating, whether the load is continuous, transient or short-circuited. Overheating is prevented by cooling of the fluid in case of higher ambient temperatures.

High starting power 
Needed to start up high inrush current loads such as inverters for LED lamps, halogen bulbs or power tools.

PowerControl – Handle with care the limits of generator, shore or supply power (800 VA/1200 VA)
The Multi Control panel will allow you to limit the incoming shore or generator power. The MultiPlus will then take the battery power into account and will only use that which is needed to prevent overloading of the shore or generator supply.

PowerAssist – Boosting the shore or generator supply (800 VA/1200 VA)
For such situations, the MultiPlus will immediately and instantaneously support the weak shore or generator supply with power taken from the battery. Where the peak of the load is reduced, the excess power is again used to charge the batteries.

Search Mode 
If the Search mode is switched on, the power consumption of the inverter is reduced by approx. 70% when it is on, but no longer used. When no load is detected for 30 seconds the Multi will switch off the inverter until the inverter is switched on again by a load. If the load exceeds a pre-set level the inverter will be switched on. Otherwise the inverter will be switched on every 2 seconds for 20 msec.

Programmable relay 
By default, the programmable relay is set as an alarm relay, i.e. the relay is de-energized in case of any alarm or pre-alarm (e.g. voltage, frequency, load, battery voltage, temperature).

Remote On/Off / Battery charger On Three pole connector.

Remote monitoring and control
Monitor and control your MultiPlus and system or systems locally (LAN) or remote over the internet from anywhere in the world, using the free VRM App and free VRM Portal website. Access can be from a phone, tablet, laptop, desktop, or smart TV, depending on the chosen remote management tool. Adjustments can be made to the MultiPlus settings, to turn the MultiPlus on or off, to the Optimiser function and to select the power assist or power કરશે function. With a Color Control GX or Venus GX, there are no limits to the control: from adjusting your MultiPlus to setting up a geofencing tag for rental vehicles, and much more...