500VA 12V 20A-16A charger-inverter - MultiPlus - Victron Energy

Description

Uninterruptible AC power (UPS function)
In case of mains failure, or of disconnection of the shore or generator feed, the inverter of the Multi takes over and feeds the connected loads. This transfer is so fast (less than 20 milliseconds) that computers or other electronic equipment will not be disturbed.

Proven reliability
The full bridge topology with a toroidal transformer has been proven for years. The inverter is protected against short circuit and overheating, whether due to overload or high ambient temperature.

High start-up power
Required to start up high inrush current loads such as power-converters for LED lamps, halogen bulbs or electric motors.

Search mode
If the Search mode is set to 'on', the power consumption of the inverter is reduced by about 70% when no batteries are available. With this mode, when the Multi is operating in inverter mode, it is switched off in case of no load or very low load, and switched on again every couple of seconds. If the load has increased beyond a set level, the inverter will continue to run. Otherwise, the inverter will switch off again.

Programmable relay
By default, the programmable relay is configured as an alarm signal relay, i.e. the relay is de-energized in case of an alarm or pre-alarm (inverter almost too hot, input voltage almost too high, battery voltage almost too low).

Remote On/Off / Charger On Three-pole connector.

Remote monitoring and control
Monitor and control your MultiPlus and system or systems locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM portal website and the free VRM app. Access is from a phone, tablet, laptop or PC with different operating systems. Through the required Color Control GX or Venus GX, there are no limits to the control: from adjusting your MultiPlus to setting up a geofencing for rental vehicles, and much more...