Our products
Description
VE.Direct communication port
The VE.Direct port can be connected to:
- A computer (VE.Direct-USB interface cable required).
- Apple and Android smartphones, tablets and other devices (a Bluetooth Smart dongle communicating with VE.Direct is required).
- Fully configurable
- Reset and alarm relay outputs for low battery voltage
- Restart and shutdown/restart for low battery voltage, or Dynamic Cut-off
- Output voltage 210 - 245 V
- Output frequency 50 Hz or 60 Hz
- ECO mode sensing and ECO mode On/Off
Monitoring
Battery voltage, AC output voltage, charge indicator, alarms
Proven reliability
The full-bridge topology with a toroidal transformer has proven its reliability over many years.
The inverters are protected against short circuit and overheating, whether due to overload or high ambient temperature.
High start-up power
Needed to start up high loads, such as inverter loads for LED bulbs, incandescent bulbs or power tools.
ECO mode
In ECO mode, the inverter switches to standby (all outputs off) when no power is detected for a set period.
It then switches on again every X seconds (adjustable) to check if the load has increased.
Remote On/Off switch
A remote On/Off switch can be connected to a two-pole connector, or between the positive pole of the battery and the left contact of the two-pole connector.
Diagnostic LED
A red and green LED indicate the status of the inverter and the status of the various protections.
Inverter
Converter typePure Sine
Continuous power1000W
Peak power2200W
V - Continuous power at 40°C
---850W
AC output voltage230VCA ou 120VCA +/- 3 % (réglable)
Frequency50 Hz
Efficience max.92%
No-load consumption10W
V - No-load consumption ECO mode3W
Configurator
Compatible with ShadingNo
CARACTéRISTIQUES GENERAL
Marque ENVictron Energy
Standard AC outletsSchuko FR
Battery voltage24V
ProtectionsCourt-circuit en sortie /surcharge /tension de batterie trop élevée /tension de batterie trop faible /température trop élevée
Voltage range18.4V - 34V
V - Low battery restart21.8V
V - Charged battery detection28V
Operating temperature-40 à +65°C (refroidissement par ventilateur)
V - Material and colorChâssis en acier et couverture en plastique (Bleu RAL 5012)
V - Battery connectionBornes à vis
V - Maximum cable cross-section25 mm² / AWG4
V - Degree of protectionIP21
Humidity (non-condensing)95%
Remote on/off switchOui
V - Automatic transfer switchFilax
Dimensions H x L x P117 x 232 x 327
Net weight (kg)7.4
Garantie Fabricant5 years
Store Warranty2 ans
CertificatesEN 55014-1 / EN 55014-2 / IEC 61000-6-1 / IEC 61000-6-2 / IEC 61000-6-3
Popular products from category
