2000VA 48V 25A MultiPlus Charger-Converter - Victron Energy

The MultiPlus combines a converter and a charger in a single unit. Among its many functions, it includes a pure sine wave inverter, adaptive charging, hybrid PowerAssist technology, and multiple system integration features.

Multifunctional, with intelligent energy management

The MultiPlus combines a powerful sine wave inverter, a sophisticated charger with adaptive charging technology, and an ultra-fast AC transfer switch in a single compact unit. In addition to these basic functions, the MultiPlus offers many advanced features described below.

Two AC outputs

The main output has an uninterrupted power supply function. In the event of a grid failure or disconnection of shore or generator power, the MultiPlus takes over powering the connected loads. This transfer is so fast (less than 20 milliseconds) that the operation of computers or other sensitive electronic equipment connected will not be disrupted. Virtually unlimited power thanks to parallel operation Up to 6 Multis can operate in parallel to achieve higher output power. 

Three-phase configuration

In addition to parallel connection, three units can be configured for a three-phase output. But that's not all: with three strings of six units in parallel, a 45 kW / 54 kVA three-phase inverter and a 1,260 A charger can be installed.

Split-phase options.

Two units can be stacked to provide 120-0-120 V, and additional units can be mounted in parallel up to a total of 6 units per phase.

PowerControl: adapt to generator, shore, or grid limits

The MultiPlus features a very powerful battery charger that draws high currents from shore or generator connections. The Multi Control panel allows you to limit the power supplied by the shore or generator. The MultiPlus then takes into account the other AC loads and will only use the excess for charging, thus avoiding any overload of the shore or generator power supply.

PowerAssist – More power from shore or generator

This function adds another dimension to the PowerControl principle by allowing the MultiPlus to supplement the capacity of the alternative source. In the event of a peak power demand, often required for a short duration, the MultiPlus will ensure that insufficient generator or shore power is compensated by additional power from the battery. And when the demand decreases, the excess power is used to recharge the batteries.

Four-stage adaptive charging and charging of two battery banks

The main output provides powerful charging to the battery system thanks to sophisticated adaptive charging software. The software adjusts the three stages of the automatic process to adapt to the battery's condition, and adds a fourth stage for long float charging periods. The adaptive charging process is detailed in the Phoenix Charger datasheet and on our website, in the Technical Information section. In addition, the MultiPlus will charge a second battery using a compensation charge output intended for a starter motor or generator starter battery.

System configuration has never been easier; once installed, the MultiPlus is ready to use. If settings need to be changed, it can be done in minutes with a DIP switch setting procedure. Even parallel or three-phase operation can be programmed with DIP switches: no computer is needed! VE.Net can be used instead of DIP switches. Sophisticated software (VE.Bus Quick Configure and VE.Bus System Configurator) is available to configure several new and advanced functions.