500VA 24V Phoenix VE.Direct Converter - SCHUKO - Victron Energy

Description

VE.Direct communication port
The VE.Direct port can be connected to:

• A computer (VE.Direct to USB interface cable needed).
• Apple and Android smartphones, tablets, MacBooks and other devices (a Bluetooth Smart dongle communicating with VE.Direct is needed).

Fully configurable:

• Low battery voltage alarm reset and trigger levels
• Low battery voltage cutoff and reset levels
• Dynamic Cut-off: cutoff set point as a function of the load
• Output voltage 210 - 245 V
• Output frequency 50 Hz or 60 Hz
• ECO mode on/off and ECO mode detect level

Monitoring:

• Input and output voltage, load percentage and alarms

Proven reliability
The full bridge topology with toroidal transformer has been proven in commercial products for many years. The converters are short-circuit protected and protected against overheating, whether due to overload or high ambient temperature.

High start-up power
Needed to start-up high inrush current loads such as inverters for LED lamps, halogen bulbs or power tools.

ECO mode
In ECO mode, the inverter will switch to standby, in which all non-essential circuits are switched off. In standby mode, the inverter switches on for a short period of time every second to power an inverter. If the load has increased above a set point, the inverter will revert to being continuously available.

Remote on/off.
A remote on/off switch can be connected to a two-pole connector, or between the positive pole of the battery and the left contact of the two-pole connector.

Diagnostic LEDs
Please check the manual for a description.

To transfer the load to other AC sources: the automatic transfer switch
For our low power inverters, we recommend the use of our automatic transfer switch Filax. The Filax has a very short transfer time (less than 20 milliseconds) so that computers and other electronic equipment will continue to operate uninterrupted.