500VA 24V 10A MultiPlus charger-inverter - Victron Energy

Description

Uninterruptible AC power (UPS function)
In case of mains failure, or of disconnection of the shore or generator supply, the inverter of the Multi takes over and feeds the connected loads. This transfer is so fast (less than 20 milliseconds) that computers or other electronic equipment will not be disturbed.

Proven reliability
The full bridge topology with a toroidal transformer has proven its reliability over many years. The inverter is protected against short circuit and overheating, whether due to overload or high ambient temperature.

High start-up power
Needed to start up high start-up current loads such as inverters for LED lamps, halogen lamps or power tools.

Search mode
If the Search mode is switched on, the inverter's power consumption is reduced by about 70% when no power is available. With this mode, when the Multi is operating as an inverter, it is switched off in case of no load or very low load, and switched on again every couple of seconds. If the load increases above a set level, the inverter is switched on. Otherwise, the inverter will switch off again.

Programmable relay
By default, the programmable relay is configured as an alarm relay, i.e. the relay disconnects in case of an alarm or pre-alarm (converter almost too hot, input ripple voltage almost too high, battery voltage almost too low).

Remote On/Off / Charger On Three-pole connector.

Remote monitoring and control
Monitor and control your MultiPlus and system or systems locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM Portal website and the free VRM app. Access is from a phone, tablet, laptop or PC with different operating systems. Through the required Color Control GX or Venus GX, there are no limits to the control: from adjusting your MultiPlus to configuring a geofencing for rental vehicles, and much more...