500VA 12V Phoenix VE.Direct Converter - SCHUKO - Victron Energy

Description

VE.Direct communication port
The VE.Direct port can be connected to:

• A computer (VE.Direct to USB interface cable needed).
• Apple and Android smartphones, tablets, MacBooks and other devices (a Bluetooth Smart dongle communicating with VE.Direct is needed).

Fully configurable:

• Low battery voltage alarm reset and reset levels
• Low battery voltage cutoff and reset levels
• Dynamic Cut-off: cut-off voltage dependent on the AC load
• Output voltage 210 - 245 V
• Output frequency 50 Hz or 60 Hz
• ECO mode on/off and ECO mode detect level

Monitoring:

• Input and output voltage, load percentage and alarms

Proven reliability
The full bridge topology with a toroidal transformer has proven itself in a wide range of applications for many years. The inverters are short-circuit proof and protected against overheating, whether the consequence of overload or high ambient temperature.

High start-up power
Needed to start high load currents such as the inverter load of fluorescent lamps with electronic ballasts, or other inductive loads.

ECO mode
In ECO mode, the inverter will switch to standby when the load drops below a preset level (minimal load: 15 W). Once in standby, the inverter will switch on for a short period (adjustable; default: every 2.5 seconds). If the load exceeds the preset level, the inverter will switch on again.

Remote on-off.
A remote on-off switch can be connected to a two-pole connector, or between the positive battery terminal and the left contact of the two-pole connector.

Diagnostic LEDs
Please see the manual for a description.

To transfer the load to other AC sources: the automatic transfer switch
For our low power inverters, we recommend the use of our automatic transfer switch Filax. The Filax has a very short switchover time (less than 20 milliseconds) so that computers and other electronic equipment will continue to operate uninterrupted.