5000VA 48V Pure Sine Wave Inverter Phoenix - Smart - Victron Energy

Bluetooth integrated: fully configurable using a tablet or smartphone

• Low battery voltage alarm
• Low battery voltage reset and cut-off levels.
• Dynamic cut-off: cut-off level dependent on the load
• Output voltage: 210 – 245 V
• Frequency: 50 Hz or 60 Hz
• ECO mode detection level and ECO mode on/off
• Alarm relay

Monitoring:

Input and output voltage, load and alarms

VE.Direct communication port

The VE.Direct port can be connected to a computer (VE.Direct-USB interface cable required) to configure and
monitor the same parameters

Remote on/off.

A remote on/off switch or relay contact can be connected to a two-pin connector.

Diagnostic LED

For our low-power inverters, we recommend using our Filax automatic transfer switch. The Filax has a very fast transfer time (less than 20 milliseconds) so that computers and other electronic equipment can continue to operate without interruption. Otherwise, please use a MultiPlus equipped with an integrated transfer switch.

Proven reliability

The inverters are protected against short circuits and overheating, whether due to overload or high ambient temperature.

High starting power

Required to start loads such as power converters for LED bulbs,
halogen lamps or power tools.

ECO mode

In ECO mode, the inverter will switch to standby if the load drops below a predetermined value.
Once in standby, the inverter will turn on for a short period of time every 2.5 seconds (adjustable).
If the load exceeds the pre-set level, the inverter will remain on.