250VA 24V pure sine wave inverter Phoenix VE.Direct-Victron Energy

Description

VE.Direct communication port
The VE.Direct port can be connected to:

• A computer (VE.Direct-USB interface cable needed).
• Apple and Android smartphones, tablets, MacBooks and other devices (a Bluetooth Smart dongle communicating with VE.Direct is needed).

Fully configurable:

• Low battery voltage alarm reset and threshold
• Low battery voltage cutoff and reset
• Dynamic Cut-off: cut-off threshold varying with the frequency of the load
• Output voltage 210 - 245 V
• Output frequency 50 Hz or 60 Hz
• ECO mode on/off and ECO mode threshold

Monitoring:

• Input and output voltage, load percentage and alarms

Proven reliability
The full bridge topology with a toroidal transformer has proven its reliability over many years. The inverters are short-circuit proof and protected against overheating, whether due to overload or high ambient temperature.

High start-up power
Needed to start-up high loads such as inverters for LED- and halogen lamps, power tools and the like.

ECO mode
In ECO mode, the inverter will switch to standby whenever the load decreases below a preset level (minimum load: 15 W). Once in standby, the inverter will switch on for a short period of time every few seconds (adjustable; default: every 2,5 seconds). If the load exceeds the preset level, the inverter will switch on again.

Remote on-off.
A remote on-off switch can be connected to a two-pole connector, or between the positive battery pole and the left contact of the two-pole connector.

Diagnostic LED's
Please check the manual for a description.

To transfer the load to other AC sources: the automatic transfer switch
For our low power inverters, we recommend the use of our automatic transfer switch, the Filax. The Filax has a very short transfer time (less than 20 milliseconds) so that computers and other electronic equipment will continue to operate uninterrupted.